EPEVER Photo voltaic CHARGE CONTROLLER SETUP: TRACER AN SERIES CONTROLLE

EPEVER Photo voltaic CHARGE CONTROLLER SETUP: TRACER AN SERIES CONTROLLE

Blog Article

The EPEVER Tracer AN Collection Solar Demand Controller is often a highly effective solar controller created for off-grid photo voltaic devices. According to multiphase synchronous rectification technologies, it makes certain optimized Electricity conversion and procedure steadiness for a wide range of photovoltaic (PV) applications.

Important Functions in the EPEVER Tracer AN Sequence Controller
The Tracer AN sequence makes use of EPEVER Solar Cost Controller technological innovation for remarkable photo voltaic Electricity harvesting. Critical options involve:

Multiphase Synchronous Rectification (MSR) for enhanced Electrical power conversion.
Highly developed MPPT Algorithm with >99% effectiveness.
Twin-Stage Charging for enhanced battery daily life.
Liquid crystal display Screen with true-time knowledge checking.
Various Load Manage Modes like manual and timer.
Complete Digital Protections versus overcharging, about-discharging, shorter circuits, and reverse polarity.
Action-by-Stage Information to Organising the EPEVER Tracer AN Sequence Controller
1. Unboxing and Getting ready the Controller
Make sure all components are included: Tracer AN device, temperature sensor, interaction cables, and consumer guide.
Verify the design selection and voltage ratings match your photo voltaic panel and battery technical specs.
2. Mounting the Demand Controller
Select a properly-ventilated, dry site near the battery lender.
Protected the Tracer AN controller using the delivered mounting brackets.
Preserve correct clearance for warmth dissipation.
3. Wiring the Photo voltaic Charge Controller
Caution: Normally observe suitable security protocols and ensure the procedure is run off ahead of connecting elements.

Step one: Hook up the battery terminals for the charge controller (favourable to beneficial, adverse to negative).
Step 2: Hook up the solar panel array to the PV enter terminals.
Phase 3: Join the load terminals if utilizing a direct load relationship.
Phase 4: Double-Look at all connections for polarity and tightness.
four. Configuring the Controller Settings
Power to the controller by connecting the battery very first.
Use Read more the Liquid crystal display Show to navigate the configurations menu.
Configure:
Battery Variety: AGM, GEL, Flooded, Lithium.
Charging Parameters: Absorption voltage, float voltage.
Load Handle Modes: Handbook, timer, gentle Manage.
five. Monitoring and Data Logging
The Tracer AN Sequence supports authentic-time monitoring utilizing the MT50 remote meter.
Facts may be logged through the RS485 communication port utilizing application like Photo voltaic Station Computer.
Distant monitoring can be done Together with the EPEVER WiFi module.
six. Troubleshooting Typical Troubles
Difficulty one: No Electricity Output

Verify battery voltage and connections.
Validate PV panel voltage exceeds battery voltage.
Issue two: Above-Voltage Protection

Confirm the photo voltaic array’s voltage rating.
Regulate method parameters if necessary.
Challenge three: No Battery Charging

Inspect PV wiring for continuity.
Verify MPPT configurations in the menu.
Benefits of the Tracer AN Sequence with MSR Engineering
The multiphase synchronous rectification technology assures:

Higher Effectiveness: Reduced energy losses for the duration of conversion.
Enhanced Dependability: Secure efficiency under variable loads.
Extended Battery Everyday living: Consistent and precise charging profiles.
Summary
The EPEVER Solar Cost Controller with multiphase synchronous rectification technology is surely an Remarkable choice for optimizing solar power technology and extending battery existence. By next the above setup tutorial, users can make certain greatest performance and method longevity.